1m (3ft) Cisco SFP-25G-AO01-I Compatible 25G SFP28 Industrial Active Optical Cable
The SFP-25G-AO01-I compatible AOC cable provides 25G connectivity for Cisco equipment over a fixed 1m (3ft) assembly. Both ends use the stated SFP28 arrangement. It is inspected and functionally checked before packing, with handling guidance designed to protect the connectors during installation and later service.
OEM Part Number: SFP-25G-AO01-IHT Part Number: SFP-25G-AO01-I
Product Highlights
- 25G AOC direct-attach assembly
- Exact cable length: 1m (3ft)
- SFP28 interface configuration
- 850nm optical interface
- OM3 cable media
- Prepared for hosts requiring Cisco SFP-25G-AO01-I
Specifications
| Part Number | SFP-25G-AO01-I |
|---|---|
| Form Factor | SFP28 |
| Max Data Rate | 25.78125Gbps |
| Wavelength | 850nm |
| Cable Type | OM3 |
| Minimum Bend Radius | 30mm |
| Cable Length | 1m(3ft) |
| Power Consumption | < 1W |
| Jacket Material | OFNP |
| Industrial Temperature Range | -40 to 85°C (-40 to 185°F) |
| Protocols | SFP28 MSA，IEEE 802.3by 25GBASE-SR |
| OEM Part Number | SFP-25G-AO01-I |
| Host Compatibility | Cisco |
| Manufacturer | HT |
Exact Length and Product Identity
This product page covers SFP-25G-AO01-I in 1m (3ft). The OEM reference, physical length and HT factory configuration should remain together on the purchase order and receiving record. Other reaches or compatibility identities must be selected and verified separately rather than assumed to be interchangeable.
Cable Construction and Installation Planning
This 1m (3ft) active optical assembly integrates the cable and optical engines, so no separate transceivers or patch leads are required. The stated OM3 construction and 850nm optics must be matched at both hosts. Route the assembly without pulling on either connector and observe the listed bend limit throughout the managed path.
Field Installation and Maintenance
Inspect the route and both connectors before installation, then support the cable without pulling on either connector housing. During maintenance, release the latch properly rather than using the cable as a handle. Keep protection on unused ends, and if the assembly is removed for later use, coil it loosely and record its part number so the same length can be returned to service.
Cisco Compatibility and Factory Testing
A field-ready cable needs both correct identification and a stable operating link. Our pre-packing check therefore includes the connectors, host recognition and link behavior. For equipment with uncertain revision history, providing the host model and software release helps identify compatibility requirements before the assembly reaches the installation site. Factory acceptance includes connector inspection, host identification, optical receive activity and an operating link. Both ends remain attached to the cable; they are not interchangeable standalone modules.
Ordering Information
Request the cable by its exact part number and length, and state the equipment model if compatibility confirmation is needed. Site orders can list quantities by rack or installation team. Any requested label should retain the part number so a removed or spare cable can still be identified accurately. This page describes SFP-25G-AO01-I in 1m (3ft); quote this exact reference and length together with quantity and the intended host platform.
Quality Assurance and Packaging
The cable and both connectors are inspected before a functional link test. Connector protection and bend-safe packing reduce handling damage during transport and storage. Customer or site labels can be added for field inventories, with different lengths separated to simplify issue and return of spare assemblies.
Shipping and Lead Time
Standard configurations normally ship within one to three working days, while production quantities are confirmed with the order. International express, air cargo and sea freight can be selected according to destination and carton volume; customer courier accounts and nominated forwarders are also accepted.
